Your Cart is Empty
$7.49
The Adjustable Angle Connector is one of the most versatile structural pipe fittings in the Maker Pipe building system. You can choose from two available sizes that are designed to natively fit either 3/4" or 1" EMT Conduit respectively. EMT Conduit is readily available at your local hardware store. The 1/2" connector variant includes the needed adapter shims for building with 1/2" EMT Conduit.The Adjustable Angle Connector gives you the ability to achieve any angle up to 90 degrees in either direction. Use the provided hardware to secure two pipes at a desired angle or partially tighten the top bolt and nut to create a hinge.
*Hardware is included with each Adjustable Angle Hinge Connector
The Adjustable Angle Connector consists of four pieces. The two long pieces secure a terminating pipe and create the end clamp. The two smaller pieces have interlocking puzzle pieces that secure a through pipe and create the puzzle piece clamp. You can buy all four pieces together or buy the bottom/top half separately if you need one and not the other.
I use these and other Maker Pipe fittings for building Christmas light show prop frames and supports. I've found there's always that angle or two that simply can't be done with anything else. For example, I have Boscoyo Studio's Mary, Joseph and baby Jesus coro nativity props but not their $200 stable. I built my own stable with 1/2" EMT and 3 Boscoyo's ChromaTrim V5 strips which cost $2.90 per 7'9" length. I used 2 adjustable angle hinge connectors on the stable's roof. I also attached all the props to the stable's EMT frame so it is one piece. I then attach it to a wooden fence with conduit hangers. Below is Boscoyo's with mine next to it. Sorry for the bad photo it's leaning against a matrix. It's not perfect but at night it looks great.
The hinge worked exactly how I hoped it would! I needed to manufacture a replacement support for the slideouts on an old pop-up camper because I couldn't find new ones anywhere. Maker Pipe delivered exactly what I needed for a hassle-free job!
I did not know about this item. WOW. I will be purchasing more items in the future. Thank you gilly
I just ordered 2 end clamps. I must admit they did clamp on quite well. Although I can see that somewhere down the line I am going to have to drill holes and put at least 1 self tapper in to stop it sliding off. I was expecting the piece to fully enclose the 3/4 pipe. It didn't. There is a gap.
It does what I want it to do but none of the stuff I ordered is plug and play. Everything needs to be pinned by drilling and using self tappers or nuts and bolts. The whole friction idea is a bust. For a few things it might work but overall figure on drilling and adding additional fasteners.
