This clamp can be used to replace the standard connector bolt and create quick release connections with our 3/4" and 1" EMT Conduit Connectors. You don't need any tools for connector assembly when using this clamp. It is a great solution for builds that need to be taken apart or rebuilt quickly. When assembling, make sure the flat edge of the spacer is facing the connector. Check out the overview and strength testing in the video below.
*Clamps sold individually with nut. T Connector not included.
I use these as part of the brake system for the SpinTwist Paint Rig, and they work perfectly.
I bought some of these recently to ease assembly of the low poly tunnel framing for my raised beds. After fitting the plastic adapter shims onto the EMT, I was unable to loosen the quick clamp enough (without the nut falling off!) to allow the tee connector to slide over the shim. If the screw was only about an 1/8” (3.2 mm) longer it would’ve likely worked. Too bad.