The 45 Degree structural pipe fitting is used to add creative angles or strong bracing to any pipe project. Designed to fit inexpensive ¾ inch EMT conduit which is readily available at your local hardware store. This connector adds a 45 degree pipe to another piece of conduit allowing the builder to achieve structure reinforcement and clean angles. The clamp design allows you to quickly change a connection while building or remove and reuse the connectors in a future project.
Every connector we offer features a steel construction and a corrosion resistant black e-coating. This means your build is better protected indoors and out. Combine these connector features with the strong and durable nature of galvanized steel conduit and you get an affordable yet sturdy building platform.
*Hardware and extra friction bands are included with each 45 degree connector
The 45 degree conduit connector includes two mirrored pieces that interlock together with the puzzle piece design. The two pieces clamp together with a single nut and bolt. Both pieces are designed with a pocket feature that locks the nut into place when tightening, this allows for a one tool assembly no matter which side the nut is on. Every connector comes with a pre applied friction band that makes connections even more secure. Order the 45 degree pipe connector to add bracing or clean angles to your build!
I bought mine and used them to support a small platform to make a shelf in the Christmas tree for the cats. They’re incredibly sturdy and self explanatory to install.
Normally I use Maker Pipe for shelves, chairs and wizard boxes. This time I made supports for a cement chute. The angle connectors really strengthen the entire design.
I used the maker pipe “T connections” and their “45° connections” to build a sturdy frame for sail shades on my boat. Results far exceeded expectations. Able to adjust design easily to match final dimensions of sail shades. The cost is much less than frames available on the market. My friends have been totally impressed. The maiden voyage at Perdido key was a big success. Got a lot of looks cruising the. ack bay pulling into the Flora Bama Yacht Club!!!! The folks at maker pipe were very helpful in providing double length spacers to attach to the cleats of my boat
I used the 45 Degree fitting and was able to support an above ground pool ladder. I added one on each side of pool ladder outside of the pool and ran pipe down to the ground giving it side to side stability.
Thanks for building special pipe fittings I could not find anywhere else !!